how can I debug script called by macro>

[AppAust]

I have a script that contains dialog to get various values.
Depending on values the script then calls other scripts via the macro> command passing various paramaters.

My question is how can I debug the called macro?

Thanks.

[Marcus Tettmar]

You would have to open that other macro up separately, set the parameter values as variables at the top temporarily and debug.

Another way would be to use Include instead of Macro.

[BAM]

Dear Marcus,
can you write an example? I have the same issue. Cannot debug a scipt calle from another scrip with parameters.
Thank you in advance.
Massimo Tivan
Banca Alpimarittime Bank

[Grovkillen]

I use include for this reason, the code in the included file will be shown in the editor when you run your code.

[PepsiHog]

The way I prefer doing this is to combine them together. Eliminate the macro call. Then debug. Once it works, split the two apart again.

Include shows the code included when it's running but then disappears when it stops. Makes debugging difficult.

Good Luck,
PepsiHog