Hey all,
is it possible to have a keybind that will run the record macro and have saved settings be ran?
kinda a pain to have to go to record every time and reset all my settings.
Hope its possible
cheers!
Hotkey Record keybind and saved settings
Moderators: Dorian (MJT support), JRL
-
Joelyboy0991
- Junior Coder
- Posts: 24
- Joined: Thu Oct 11, 2018 1:19 pm
-
Marcus Tettmar
- Site Admin
- Posts: 7395
- Joined: Thu Sep 19, 2002 3:00 pm
- Location: Dorset, UK
- Contact:
Re: Hotkey Record keybind and saved settings
I'm not sure I understand your question.
Any macro can be made to read settings from a file / can be parameterised. You can make code generic and should not have to re-record anything unless you are changing ALL the steps.
Any macro can be made to read settings from a file / can be parameterised. You can make code generic and should not have to re-record anything unless you are changing ALL the steps.
Marcus Tettmar
http://mjtnet.com/blog/ | http://twitter.com/marcustettmar
Did you know we are now offering affordable monthly subscriptions for Macro Scheduler Standard?
http://mjtnet.com/blog/ | http://twitter.com/marcustettmar
Did you know we are now offering affordable monthly subscriptions for Macro Scheduler Standard?
-
Joelyboy0991
- Junior Coder
- Posts: 24
- Joined: Thu Oct 11, 2018 1:19 pm
Re: Hotkey Record keybind and saved settings
hey marcus,
sorry i don't think i was specific enough.
To start the macro recorder i need to manualy click on the record button and then
apply my settings>click start Note: i do use the Low Level Conversion setting alot!
and in doing so it records my mouse from the time and point i kick on start (witch starts recording Mousemoves that i need to snip out each time)
it would be nice to be able to hotkey or run a file/macro to start recording from where ever i choose(where my mouse is at) and also to not have to reconfigure the setting each time. Hope this was more clear cheers!
sorry i don't think i was specific enough.
To start the macro recorder i need to manualy click on the record button and then
apply my settings>click start Note: i do use the Low Level Conversion setting alot!
and in doing so it records my mouse from the time and point i kick on start (witch starts recording Mousemoves that i need to snip out each time)
it would be nice to be able to hotkey or run a file/macro to start recording from where ever i choose(where my mouse is at) and also to not have to reconfigure the setting each time. Hope this was more clear cheers!
