how to close application error window

khalil · Post by **khalil** » Mon May 17, 2004 7:38 pm

Application Error : The instruction at ........... The memory could not be "read".

Click on OK to terminate the program
Click on CANCEL to debug the program

the program that i use keeps crashing. is there a command or something that could close this error message ?

Bob Hansen · Post by **Bob Hansen** » Mon May 17, 2004 9:26 pm

You could check to see if the error window is open. If YES, then you could enter a click on the OK button. Then you can decide to continue or to jump to some other macro location and/or End the macro. Something like this:

IfWindowOpen>ErrorWindowName*,Close,Continue

Label>Close
PushButton>ErrorWindowName*,OK
Let>MsgString=Application Error : The memory could not be "read".
Goto>LabelName
...
...
Label>Continue
Let>MsgString=No Error Messages. Process was successful.
...
...
Label>End
Message>MsgString

Be sure to remove Trailing Space Characters from Cut/Paste on the forum.

khalil · Post by **khalil** » Tue May 18, 2004 4:23 pm

thanks