i have one .ini file with any informations, like this:
*****************
//Dynamicvariable
[task_all]
anzahl=6
[wt1]
waittime=90
[1]
nextrun=23:21:00
name=Name1
todo=
aktiv=1
[2]
nextrun=19:03:51
name=Name2
todo=
aktiv=1
[3]
nextrun=15:24:51
name=Name3
todo=
aktiv=0
[4]
nextrun=22:15:01
name=Name4
todo=
aktiv=1
[5]
nextrun=17:18:51
name=Name5
todo=
aktiv=0
[6]
nextrun=12:43:22
name=Name6
todo=
aktiv=1
.....
*******************************************
I will read the information on [1] and the value of name
then, i will put it to the arry
the max. inputs, where i have, is = [task_all] and the value from the anzahl, here it is 6,
so, i must have a arry with 6 informations.
(for the array definition)
then i do somthing, and after a few other scripting stepps, i will read the information from the .ini file again, but at the point [2] and then the value from the name, and then i will put it to the same arry, what i have use before, with the first stepp. It not the same variable name from [1], [2], [3].... all the names are different.
and this stepps i will do so often again. until, i have read all the informations fromt the point from the value names...
so, when i was ready, i will have, this example here, i will have 6 informations all in all, at the array.
and when i have the informations, i will push the informations from the arry to a post box (Listbox).
so, the only funktions of the array is, to accumulate ( or truss) the information, that i can publicate these informations with one stepp, to the list box.
my problem is, that i dont know, how can i fill the arry, step by step with the informations.
Just at the moment, i fill the arry with a informations, and at the next stepp, i dont add the next informations, i overwrite the existing informations, so, i have all the time, only 1 informations at this array.
Any one any informations or help for me?
Sorry, about my bad english!
