When I change a Hot Key on a macro now in version 11.1 :
- - I double click the macro from the main window
- macro opens in the new editor
- I click the "Hot Key" tab and select a different Hot Key
- there is no OK or Apply button to click so I just click the X in the upper right corner to close the macro
- it sees I've changed the Hot Key so it asks if I want to save the change, I click yes, the macro closes, done.
Not so with the lower method. If I have a Hot Key set there, I can deselect the checkbox then click the X and it closes the macro but leaves the Hot Key there... it did not notice the change. I can even click into the field, type some other Hot Key combination, the new keys show in the field... then I click the X and again, it fails to notice the change, it closes the macro and the Hot Key has not been changed.
Can it be made to sense changes in the Hot Key or checkbox on the lower method... just like it does on the top?
Finally, while testing Hot Keys, I noticed this one is still an issue in 11.1:
- [Open] Bug with Hot Key: Num *
http://www.mjtnet.com/forum/viewtopic.php?t=4533
Thanks Marcus and take care